Specifications

Viper Installation and Operators Manual 2.08
146
See the table below for an example of boom mapping information.
Mapping the Booms
1. From the Boom Setup Summary screen, press the Map Booms button.
The Map Booms to Wired Setup screen will display.
2. Change the order of the booms by entering a new order number in the
‘Wired As’ fields.
3. Change the display number for each boom by entering the new boom
number in the ‘Display Character’ fields.
Important: Viper will not allow ‘Wired As’ sections to be
skipped. For example, if you have 3 boom sections, ‘Wired
As’ must be 1, 2, and 3 in any order. You could not have
these three sections ‘Wired As’ 1, 2, and 4. To skip a boom
section, a boom must be configured with ‘0’ width.
4. If you have more than five booms, press Next to change the order for
booms 6 through 10. If not, skip to step 7.
Logical Wired As Display Character
11 L
22 1
33 2
44 3
55 4
66 5
77 *
88 *
99 R