Specifications

Manual # 016-0159-894 Rev H 01/07
135
3-Navigating the Viper Interface
3. Enter the antenna height to the nearest half foot.
4. If a reverse switch is used, select the corresponding high (12V) or low (0V)
for Reverse Polarity.
5. Select the desired Tilt Filter setting.
Zeroing the Tilt Sensor
To zero the tilt sensor:
1. Drive the machine to a known level position.
2. Ensure that Slow, Norm, or Fast is selected for the Tilt Filter.
3. Press the Operator Zero button.
After the tilt sensor has been calibrated, ensure that the tilt reading in the status area
reads 0.0°.