Specifications

Viper Installation and Operators Manual 2.08
130
3. Once the DGPS configuration is complete and communications are present,
press View Data. The data strings coming from the DGPS receiver will be
displayed.
4. Press Cancel to return to the GPS Comm Port Setup Screen.
GPS receivers output position information relative to the antenna location. Most
often, the GPS receiver is mounted on the top of the machine. If the machine is on
level ground, the GPS location is correct. If the machine runs on uneven terrain
such as on side hills, the ground position of the machine may differ from the location
of the GPS receiver. The Raven TM1 Tilt sensor compensates for any tilt of a
vehicle from a level field condition. The Raven TM1 tilt sensor must be installed
between the GPS receiver and the Viper as shown in the drawing.
If you have a Raven TM1 installed between the GPS receiver and the Viper, you
can set up the tilt sensor on the Viper screen.
Tilt
Sensor