Specifications

Viper Installation and Operators Manual 2.08
4
Decreasing the Backlight Intensity
1. Press and hold the Menu button.
2. Press the DOWN arrow key until you reach the desired intensity.
3. Release both buttons.
Connectors
The rear of the Viper console has two connectors, the Power connector and the Interface
connector.
You must connect the power and interface cables to the appropriate connectors to use the
Viper console.
Flashdisk Storage Card
Viper uses information stored on the flashdisk in order to operate while running. You must
have a flashdisk installed prior to turning on the power to the Viper console. If you are using
more than one Viper console, you must have a separate flashdisk for each one.
Mounting
Bracket
Interface
Cable
Speaker
Power
Cable