Specifications

Manual # 016-0159-894 Rev H 01/07
129
3-Navigating the Viper Interface
Raven GPS + Lightbar Setup
This feature allows you to set up a Raven DGPS receiver and Raven Lightbar. This
feature is available only if you have purchased the Guidance feature and you want to
control the external lightbar from the Viper screen.
You can auto-configure the follow Raven receivers:
 Invicta 110
 Invicta 115
 Invicta 210
 Invicta 310
Make sure that the Raven receiver is properly connected and powered up before
configuring it with the Viper system.
The Raven Lightbar must have firmware 2.3 or higher and the Raven receiver must
have firmware 4.07 or higher for this configuration to work correctly.
Important: Only select this setting if you want the external lightbar
to be controlled by the Viper system.
Configuring a Raven DGPS Receiver + Lightbar
1. Select Menu, then Setup, and Comm Ports. The GPS Comm Port Setup
screen displays.
2. Select Raven GPS + Lightbar. Viper automatically configures the Invicta
receiver with the following output:
 Port A/B Baud = 19200
 Data Bits = 8
 Stop Bit = 1
 Parity = None