Specifications

Manual # 016-0159-894 Rev H 01/07

1-Getting Started

with the Viper System

Keypad

You can use the keypad on the lower part of the Viper console for additional functions. The

following is a description of the buttons on the keypad:

1. PWR: Press this button to turn on the Viper console. The Viper console takes

approximately 15 seconds to power up. Press this button again to turn the Viper

console off.

Important Make sure to close any open job before turning off the power.

Failure to close a job before turning off the Viper console may result in a

loss of information for that job.

2. ESC: This button does not have any functionality at this time.

3. MENU: Press this button along with the UP/DOWN arrow keys to adjust the

backlight. See Adjusting the Backlight section below.

4. NEXT: This button does not have any functionality at this time.

5. ARROW KEYS: Use the UP/DOWN arrow keys, along with the MENU button,

to adjust the backlight. See Adjusting the Backlight section below.

6. ENTER: This button does not have any functionality at this time.

7. F-KEYS: The F-Key buttons are used for the CAN nodes described later in this

manual.

Adjusting the Backlight

Depending upon the environment in which you are operating, you can adjust the

touchscreen backlighting intensity to better view the display. The following

procedures describe how to increase or decrease the backlight intensity.

Increasing the Backlight Intensity

1. Press and hold the Menu button.

2. Press the UP arrow key until you reach the desired intensity.

3. Release both buttons.