User Manual

8
Section 6: Change to Wall Mount
By default, the display comes pre-assembled with a stand. Open the package and
remove the foam covering. Carefully place it on the table or desktop. If you want to
switch to a wall mounted installation, you’ll need to remove the stand rst, then install
it on the wall with the appropriate VESA* accessories (not included) using the steps
below.
1. Open the package, take out the product with foam still attached, and gently place it on a
desktop or table.
2. Take out the four main screws of the stand and remove the entire stand from the monitor.
Carefully store the stand in case you ever want to change back to stand installation in
future.
Screws x 4
3. After remove the stand from the monitor, select a VESA* accessories and four M4 screws
(9mm ≤L≤15mm) to x it onto the back of monitor.
Screw Holes x 8
* Support 75x75 mm or 100x100mm VESA accessories.