User manual

Getting Started
5
1. Switch: Switch on/off the power supply.
2. AC Power IN: Connect to an earth 100-240V, 50/60Hz AC outlet with the Power Cable.
3. HDMI: Connect it to the HDMI of DVD or other equipment.
4. PC-IN: Connect it to the audio output terminal of PC.
5. VGA: For PC display. Connect it to the D-Sub 15 pins analog output connector of the PC.
6. YPbPr: (Component) Connect them to the video output terminals of DVD or other equipment.
(used in Component mode).
7. S-VIDEO: Connect it to S-Video output terminal of DVD or other equipment.
8. VIDEO: (Composite) Connect it to video output terminal of DVD or other equipment.
9. L/R Audio in: Connenct them to audio output terminals(For Video-Composite/S-Video/YPbPr-Component).
10. RF: Connect antenna or cable 75 Ohm coaxial to receive TV signal.
1
2
DVD
HDMI
VGA
Y Pb Pr S-VIDEO VIDEO R L
Audio in
RF
PC-IN
34 5 6 78 9 10
- To turn on the LCD TV
- Be sure to turn off the power and unplug both units
from the wall outlet before making any connections.
Power on
Power off
Wall Mounting
The TV is provided with mounting holes for a VESA approved wall mounting bracket(NOT
SUPPLIED). Remove the Posi screws holding the base to the base bracket and lift the
base away (do not remove the base mounting bracket). Mount the VESA bracket using
4 x M4 x10 Iso metric threaded screws (not supplied). Do not use screws longer than 10 mm,
damage will occur to the internal parts. Fit the wall bracket securely following the manufacturers
instructions.