Owner`s manual

The pin assignments of the Bravo amplifier XLR-type female

chassis input connector is

Pin 1: Signal ground

Pin 2: Signal + (non-inverting)

Pin 3: Signal - (inverting)

Connector ground lug or case: chassis ground

These pin assignments are consistent with the standards adopted by

the Audio Engineering Society. Refer to the operating manual of your

balanced-output preamplifier to verify- that the pin assignments of its

output connectors correspond to your Bravo power amplifier. If not,

wire the cables so that the appropriate output pin connects to the

equivalent input pin.

4. AC mains cord and AC mains switch

IEC standard power cords are used in the Bravo power amplifier.

Plug the cord into the high-current IEC outlet provided, and then into a

suitable wall outlet.

Your new Bravo power amplifier has been safety-tested and is

designed for operation with a three-conductor power cord. Do not

defeat the "third pin" or earth ground of the AC power cord.

Two fuses are located at the rear of the Bravo power amplifier. The

protection circuitry has been designed such that only a catastrophic

failure would cause these fuses to blow. As a result, if you suspect that

your AC fuses have blown, disconnect your amplifier from the AC

mains and check them.

Potentially dangerous voltages and current capabilities exist within

your power amplifier, even when disconnected from AC mains. Do not

attempt to open any portion of the amplifier's cabinet. There are no

user-serviceable parts inside your power amplifier. All service of this

product must be referred to a qualified VIOLA dealer or distributor.