User manual

Chapter 6
Additional System Configuration
6.1 Changing system password
Username and password can be changed from Tools->User Config screen. It is always recommended to change
the password from the factory default when the Arctic 3G is connected to a public network.
Figure 6.1: User config screen
New username and password will be active after the Arctic 3G is restarted.
6.2 Date and time
Date and time can be changed from System->Time screen. Date and time can be configured either manually
entering the time or automatically from connected PC.
Figure 6.2: System time configuration screen
To set time manually, enter the time and then press Submit button.
To copy time from PC, press Copy PC button and answer “Yes” to question about changing time. Note that
the PC may not necessarily have correct time set and that needs validation. Also note that the copy functionality
requires JavaScript support from the browser.
6.3 System log
System log is visible on the Tools->System Log screen. To refresh the system log, use web browser reload
button.
6.4 Factory default settings
Factory default settings can be applied by restarting the unit pressing down reset button until the LEDs blink.
23