User`s manual

User's Manual
Arctic IEC-104 Gateway
Firmware Version 5.0.9 48 Document Version 1.5
Parity method used on IEC-101 serial communication
Units Bits
Value range None, Even, Odd
Note
Stop bits
Table 10: Number of stop bits used on IEC-101 serial communication
Parity method used on IEC-101 serial communication
Type Serial data stop bits
Units Bits
Value range 1, 2
Note
Use HW flow control
Table 11: Number of stop bits used on IEC-101 serial communication
HW flow control mechanism (RTS/CTS) on IEC-101 serial
communication
Type Boolean
Units N/A
Value range Yes, No
Note The HW handshaking is available only on RS-232 mode.
7.3 Network settings
The Network settings define the general TCP/IP networking properties
between the Arctic and the IEC-104 master.
Figure 36. Network Settings
Network protocol
Network protocol defines the network transmission layer protocol (either TCP
or UDP) used on IEC-104 network communication. The IEC-104 standard
protocol uses TCP but for reliable slow speed packet switched networks (e.g.
Mobitex), the UDP protocol can be used to minimize the packets transmitted
over network.