User`s manual

User's Manual
Arctic IEC-104 Gateway
Firmware Version 5.0.9 28 Document Version 1.5
Use GPRS as default route – If enabled, GPRS is used as default route.
Ethernet default gateway has to disabled (Parameter “Use Ethernet as default
route” set to “No” in Network -> Ethernet).
Figure 18. GPRS Settings
5.2.3 Dial-in
Configuration for the Arctic PPP dial-in Interface.
Dial-in enabled – When enabled, PPP connections can be made to Arctic
(GSM data).
Require authentication (PAP) – When set to yes password authentication is
used for incoming data calls.
Required username – PAP username allowed login.
Required password – PAP password used for authentication.
Idle timeout – Idle time before PPP connection is terminated.
Local IP address – IP address used in PPP peer.
Peer's IP address – IP address used in PPP peer.
Maximum MTU value – MTU (Maximum transfer unit) for Dial-in connections.
5.2.4 SSH-VPN
Arctic has a VPN client that can be used with the Viola M2M Gateway. For
VPN configuration, please refer to the Viola M2M Gateway User’s Manual.