User`s manual

User's Manual
Arctic IEC-104 Gateway
Firmware Version 5.0.9 20 Document Version 1.5
3. Navigate to Network -> Ethernet page.
Figure 11. Ethernet Settings
4. Enter the Ethernet IP address (and other network settings) of your choice
and click Apply and then Commit (on bottom of page) to store the settings.
5. Reboot the Arctic for the settings to take effect.
Note!
Arctic default password is empty. Remember to set the password before
connecting the Arctic device to a public network (Chapter 5).
3.4 Setting of the IP Address Using a Console
Before installation, you need to find out the required network settings. These
include the IP Address, Netmask and Gateway Settings used by the Arctic.
The local network administrator can provide them to you or you can ask for
them from your Internet Service Provider.
Note!
If possible, it is recommended to use an HTML browser to set up network
settings as described in the next chapter. If using a console, please follow the
procedure below:
1. Before you start, turn off the power from all devices and check that the
power switch of the Arctic is in the “OFF” position.
2. Connect a serial cable (crossover) to the console serial port (RS1) and an
Ethernet cable to the RJ45 connector.
3. Switch the Arctic on by toggling the power switch to “ON” position.