Specifications

40 / 80
• Figure 46: Arctic's Ethernet settings
• Override Ethernet configuration by DHCP?
Enable only if the Arctic should fetch the Ethernet configuration from DHCP server on
Arctic’s LAN.
• Host name
The Host name of the Arctic. Host name also identifies the Arctic on SSH-VPN and
L2TP Tunnels. Each Arctic must have unique hostname in one solution. In M2M GW,
the VPN peer names must also be unique; there cannot be same peer name in e.g.
SSH-VPN setup and L2TP-VPN setup.
Note: Host names in Arctic and M2M GW’s VPN configuration are case sensitive.
Enter the VPN peer name in M2M GW exactly the same way as in Arctic.
• Ethernet IP address
The IP address of the Arctic’s Ethernet interface in Arctic’s LAN.
• Network mask
The network mask of the Arctic’s Ethernet network.
• Default gateway
The IP address of default gateway on Arctic’s LAN.
Use only when Ethernet should be used as default route.
Note: Arctic must have only one default route (Ethernet, GPRS, or VPN-Tunnel)
enabled at any time. Disable the GPRS and VPN-tunnel default gateways if you
enable the LAN default gateway.
• DNS servers
Addresses of DNS servers, if not received from cellular network. Consider leaving