Specifications

30 / 80
• Figure 33: M2M GW eth1 settings
Note: In general, do not enable “Proxy ARP”. See page 49, chapter 14.7: Configuring the
routing settings of the Arctic for more information regarding proxy ARP.
6. Click “save and apply” to make the changes permanent.
Note: The next step will manipulate the interface, which is used for your current connection to the
M2M GW. After you have changed the IP address of eth0, your browser will not be able to connect
to the M2M GW with URL https://10.10.10.10:10000
but instead you must change your installation
computer’s IP address to belong to the LAN of M2M GW.
7. Click the “eth0” text to configure the eth0 interface’s settings as in Figure 34.
• Figure 34: Configuring eth0 interface in M2M GW
8. In the “Edit Bootup Interface” screen of eth0 (Figure 35), set the interface’s attributes.
Because the public IP address of M2M GW is case dependent, it is not possible to give
any example. Set the eth0 interface’s IP address and other attributes based on the
information received from Internet service provider (ISP).
Name: eth0
Netmask: <from_ISP>
MTU: Automatic