Specifications

29 / 80
• Figure 31: M2M GW, network interfaces screen
3. As you are now connected to M2M GW via eth0
, which is the future WAN port, it is
recommended first to change the eth1
, the LAN port. In this example, the IP addresses are
set as defined in page 11, chapter 7.1: Scenario 1, M2M GW connected with public IP
address.
4. Click the “eth1” text to configure the eth1 interface’s settings as in Figure 32.
• Figure 32: Configuring eth1 interface in M2M GW
5. In the “Edit Bootup Interface” screen of eth1, set the interface’s attributes as follows
(As in Figure 33.):
Name: eth1
Netmask: 255.255.255.0
MTU: Automatic
IP Address: 192.168.0.1, static
Broadcast: 192.168.0.255
Activate at boot: Yes
Enable proxy ARP: No