Specifications
16 / 80
locked him/herself out from the Ethernet ports by firewall), but it is not usually needed, while initially
configuring the M2M GW.
The power supply of M2M GW is rated for input voltages between 100-240 Volts AC. The
connector in M2M GW is standard IEC 60320, type C14 that accepts the C13 plug, the wall socket
connector type varies country by country.
• Figure 9: M2M GW's connectors
Note: In the initial setup, connect a cross-connected Ethernet cable between the installation
computer and M2M GW's Ethernet port 1
(i.e. eth0, the WAN port). Refer to the M2M GW's quick
start guide for more details.
11.2. Cabling the Arctic
The needed cables are depending on the application and the type of Arctic used. The Arctic Router
products have only console serial port, where as the Gateway products have one serial port that
can be switched between console or application port and one serial application port.
See the Figure 10: Arctic's connectors for details.
11.2.1. The Arctic connection cables are:
• Power supply cable
Note that the Arctic is shipped without a power supply. Viola Systems Ltd. stocks power
supply with cable (part nr. 3010), contact Viola Systems Ltd. sales department for mode
details for pricing and availability. The input voltage range is 10…26 VDC.
• Ethernet cable
If Arctic is connected to a computer, a cross-connect cable is needed. A connection to a
switch is done with direct cable. Viola Systems Ltd. also stocks an Arctic Accessory Kit,