User Manual

English

Using a 2.5mm allen key, remove the screw (10.2 & 12.2) securing the brake lever.

Remove the brake lever without moving the brake shaft.

Turn the brake shaft clockwise until the brake makes contact.

Replace the brake lever onto the brake shaft at approximately 30-45 degrees from the

off position (Fig. 15).

Refit the screw (10.2 & 12.2) using the allen key.

Turn the lever clockwise and ensure that the brake is fully applied before the end stop

is reached.

Turn the lever fully counter-clockwise and ensure that the brake is fully released before

the end stop is reached.

Re-adjust the position of the lever as necessary.

Ensure that the brake is set to the off position and replace the cap (10.1 & 12.1). Ensure

that the cap is positioned with the cut-out at the top and the ‘V’ in a vertical position.

Fig. 15 Adjusting the pan and tilt brakes

(10.1)

(12.1)

(10.2)

(10)

(12.2)

(12)