User Manual

English
12
position by the slide plate clamp (13). The slide load release (14) allows rapid removal of the
slide plate (16) from the head by lifting the camera upwards.
The head is supplied with a 1/4 in. screw and pin adaptor to suit most lightweight camcorders
and two 3/8 in. camera mounting screws. When not in use, the 1/4 in. screw and pin adaptor,
and 3/8 in. camera mounting screws can be stored in the camera screw storage compartment
(18) located on the left-hand side of the camera mounting platform.
Pan bar
Pan bar mounting points (6) are located at the rear of the head on either side of the camera
mounting platform. The pan bar (5) is attached using a pan bar clamp (4), with angular
adjustment available on the mount serrations. A fixed pan bar is supplied with the Vision 3AS,
5AS and 8AS heads. A telescopic pan bar is supplied with the Vision 10AS head. A second pan
bar may be fitted on the other side of the head if required.
Field service spares kit
A field service spares kit (V4045-1902), that includes brake levers and a spare battery, is
supplied with all Vision AS pan and tilt heads. See the spares part listing on page 28 for more
information.