User Manual

Back
13
Position the two 3/8 in. camera screws (17) as far apart as possible on the camera slide
plate (16) (Fig. 4).
Attach the camera slide plate (16) to the camera or camera mounting plate approximately
under the centre of the camera's weight.
If not already done, apply both the pan brake (10) and tilt brake (12) by turning the levers
in a clockwise direction.
Lower the camera onto the camera mounting platform (Fig. 5) ensuring that the edge of the
camera slide plate (16) opposite the slide clamp (13) engages first, and then push
downward until the slide clamp ‘snaps’ into position.
Using the pan bar (5) to steady the camera, tighten the slide plate clamp (13) in a clockwise
direction to secure the camera in position.
Fig. 4 Fitting the 3/8 in. camera mounting screws
CAUTION! DO NOT use force on the brake levers. Hand tighten only.