Technical data

Back

Pozi-Loc tripod

The Pozi-Loc two-stage tripod (Fig 2) has aluminium legs and a 75 mm levelling bowl (20). It is

fitted with the highly-efficient Pozi-Loc leg clamp (21), which provides quick set-up and easy ad-

justment.

Tripod spreaders

Depending on which PRO-6

HDV

system was purchased, the tripod is supplied with either a floor

spreader (Fig 2) or a mid-level spreader (Fig 3). Both tripod spreaders increase the rigidity of the

tripod.

PRO-6 HDVF system

The PRO-6 HDVF system utilizes a floor spreader (Fig 2) which, being flexible, compensates for

uneven ground, protects floors and carpets and prevents the tripod legs sinking into soft ground.

It should be used at all times.

Each arm is of the spreader is adjustable for length (23) and the tripod feet are secured by rubber

straps (24).

PRO-6 HDVM system

The PRO-6 HDVM system utilizes a mid-level spreader (Fig 3) which fastens to the attachment

points (26). There are two spread settings, controlled by a knob (28), and the arm lengths can be

adjusted using the extension clamps (29) to compensate for uneven ground. A set of three feet

(32) are also supplied with this system to protect floors and carpets and prevents the tripod sinking

into soft ground. The feet are secured to the tripod by rubber straps (33).

NOTE: Always use the spreader where possible as this increases rigidity of the

tripod. Being flexible, the spreader compensates for uneven ground.

It can be removed and a dolly fitted.

At the fullest extension of the spreader and with all legs fully retracted, the

tripod can be used at its lowest operating height. Although the tripod can be

set up lower than this without the spreader, it is NOT recommended as the

tripod geometry becomes unstable

NOTE: Always use the spreader where possible as this increases rigidity of the

tripod. Adjustable extension clamps compensate for uneven ground.

The spreader can be removed and a dolly fitted.

At the fullest extension of the spreader and with all legs fully retracted, the

tripod can be used at its lowest operating height. Although the tripod can be

set up lower than this without the spreader, it is NOT recommended as the

tripod geometry becomes unstable