Technical data

21
Camera slide plate knob adjustment
To prevent interference with the payload, the camera slide plate knob (7) should be at or below
the horizontal when applied.
To adjust the camera slide plate knob:
Remove the securing screw (7.1) and pull the knob (7) off the shaft (7.2).
Turn the shaft (7.2) clockwise until the slide plate clamp is fully applied.
Install the knob (7) on the shaft (7.2) approximately at or below the horizontal.
Turn the knob fully counterclockwise and ensure the slide plate clamp is released before
the stop is reached. Turn the knob clockwise and ensure the clamp is applied before the
knob reaches the horizontal.
Readjust as necessary and secure the knob with the screw (7.1).
Camera slide plate knob adjustment
(7.2)
(7)
(7.1)