Technical data

16
Push a blind captive nut (27.4) into the hole in the lower moulding.
Using a suitable M5 screw, fully compress the blind captive nut. Remove the M5 screw.
Install a washer (27.3) on the lower strap anchor (27.2) and screw into the captive nut
(27.4). Ensure that the hole in the strap anchor is oriented so that the karabiner (27.1) can
be attached
On the underside of the tripod bowl (19), remove and discard the screw (27.5) securing the
corresponding leg clamp (19.2). Do not remove the washer (19.1).
Position the bowl strap anchor (27.6) on the leg clamp, ensuring it is correctly oriented. Us-
ing Loctite 221, secure the bowl strap anchor with the 25 mm M6 screw (27.5) supplied with
the strap. Tighten screw to a torque of 4.5 Nm (40 lbf in.).
Using the karabiners (27.1), clip the strap (27) to the strap anchors and adjust to length.
'Spread-Loc' mid-level spreader
The ‘Spread-Loc’ mid-level spreader (28) is available as an optional accessory. To install the
spreader:
Grip the ends of each spreader arm in turn between thumb and fore-finger and press in the
attachment release buttons (28.1).
Push the arm into the tripod attachment (25) until the release engages.
Fit the carpet feet (29).
To remove the spreader, press in the attachment release buttons (28.1) and free each arm
in turn.
'Spread-Loc' mid-level spreader
(29)
(25)
(28)
(28.1)