Specifications

Stereo Linking the M76
The M76 comes built with its Internal Stereo Link Loop set to Master. If you
bought two units at the same time New from Revive Audio, your units will already
be set up and ready for stereo use. Simply connect the ¼ TRS cable (provided
when a stereo pair is purchased) between the units Sidechain inputs and set both
units to Link (Red Led should illuminate).
If you bought one unit and are looking to add a second for stereo operation, the
new unit must have its internal loop switch set to slave. This requires you to
remove the lid and flip the toggle on the MU76 Mainboard. It is simple and
straight forward. If purchasing a second unit directly from Revive Audio merely
request that it be set to slave. Note that the Slave and Master Switch positions will
not affect the units operation in anyway unless the link switch is engaged. The
M76 will function normally when unlinked. However if the switches are not set
correctly, stereo operation will not be successful.
Back Panel Overview
Input: Signal input for left and right channels
Output: Signal output for left and right channels
External Sidechain Input: External Sidechain input for stereo linking. The Link
selector must be turned on when Stereo linking two M76’s.
AC power inlet: Simply plug in the provided AC cable and away you go.