Installation Manual WM-1500SLIM WM-1500SLIM-TE www.vinotemp.com Vinotemp International Corp 732 South Racetrack Road, Henderson, NV 89015 Tel: (800) 777-VINO Fax: (310) 886-3310 Email: info@vinotemp.
Important Safety Information • • • DO NOT PLUG IN UNTIL 24 HOURS AFTER DELIVERY. DO NOT USE A GROUND FAULT INTERRUPTER (GFI). A DEDICATED 20 AMP CIRCUIT IS REQUIRED.
Specifications and Dimensions The specifications and dimensions are listed as follows: Model NO WM1500SLIM WM1500SLIMTE Exhaust CFM Cabinet (cu ft) Electrical Rating Dimensions (in) WxDxH Weight (lb) Rear 120 90 115V/60Hz/4A 18 x 8 x 13.5 40 Top 120 90 115V/60Hz/4A 18 x 8 x 13.5 40 NOTES: • See the voltage, frequency, and current specified on the label on the cooling unit.
• • • • cabinet temperature, higher ambient temperature and less insulation will cause a reduction in capacity and may not maintain a temperature of 55°F. The ambient temperatures for WM-1500SLIM should not be higher than 78°F or lower than 50°F. Mounting brackets, screws, gaskets and other seal materials are not included. Do not install any ducts onto the supply, return, intake and exhaust.
• • • • • • • • • cooling unit must intake adequate fresh ambient-air to work properly. The ambient-air intake and hot-air exhaust must not be short-circulated. A piece of wood may be used to separate them. Cut a rectangular inside opening at the rear of the cabinet with the 1/4” clearance inwards to the width and height of the cooling unit. Make a 1/2” lip to place the gaskets (see Fig. 2.1).
Fig. 2.2 TOP EXHAUST CUTOUTS Fig. 2.
Fig. 2.4 REAR GASKETS Fig. 2.
Fig. 2.
Fig. 2.7 COOLING UNIT MOUNTED (REAR EXHAUST) Fig. 2.
Warranty Thank you for choosing a Vinotemp cooling unit. Please enter the complete model and serial numbers in the space provided: Model_________________________________________________________ Serial No.______________________________________________________ Attach your purchase receipt to this owner’s manual. 1. Limited Warranty VINOTEMP warrants its products, parts only, to be free from defects due to workmanship or materials under normal use and service for twelve months after the initial sale.
is determined to be faulty and is within the twelve month warranty period VINOTEMP will, at its discretion, repair or replace the unit and return it free of charge to the original retail customer. If the unit is found to be in good working order, or beyond the initial twelve month period, it will be returned freight collect. 2. Limitation of Implied Warranty VINOTEMP’S SOLE LIABILITY FOR ANY DEFECTIVE PRODUCT IS LIMITED TO, AT OUR OPTION, REPAIRING OR REPLACING OF UNIT.
