Manual and User Guide

CARE AND MAINTENANCE
CLEANING YOUR BEVERAGE COOLER
IMPORTANT: Always unplug the unit before cleaning or performing maintenance. Never use
harsh cleansers or scouring pads to clean any part of the unit.
• Turn off the power, unplug the appliance, and remove all items including shelves.
• Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth before cleaning control panels or any electrical
parts.
• Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
POWER FAILURE
• Most power failures are corrected within a few hours and should not affect the temperature of
your appliance. If the power is off for an extended period of time, proper steps should be
taken to protect your contents.
• Minimize the number of times you open the cooler door to help the cooler maintain
temperature in the event of a power failure.
INACTIVITY
If the unit will not be used for a period of less than three weeks, leave the cooler operating. If the
period of inactivity is several months, remove all items and turn the unit off. Clean and dry the interior
thoroughly. Leave the door open slightly to prevent any possible moisture build-up.
MOVING YOUR BEVERAGE COOLER
Before moving your beverage cooler, first be sure to remove all items from the cooler.
• Securely tape down any loose items, such as shelves, inside the unit.
• Tape the door shut.
• Ensure that the unit stays securely in the upright position during transportation. Protect the
outside of the appliance with a blanket or similar item.
DRIP PAN
• When the compressor stops working, water drops will drain through the outlet in the inner back
wall into the drip pan located above the compressor.
• If the drip pan needs to be cleaned, pull it forward gently and reinstall once you are done
cleaning.
8
WWW.VINOTEMP.COM