Manual and User Guide

INSTALLATION
• Remove all packing material before using your beverage cooler.
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water and a soft cloth.
• This unit is designed for freestanding and indoor use only. Position the unit in a dry and well-
ventilated place. Avoid placing the beverage cooler near any source of heat or moisture, or in
direct sunlight. Do NOT install the unit in a location with an ambient temperature that will fall
below 60°F.
• This unit is designed with rear exhaust, which requires a minimum of 4-6 inches clearance at the
back and 10-12 inches on each side for proper ventilation.
• Be sure to not obstruct the exhaust vent with anything as this may prevent the unit from
performing properly.
• Place the beverage cooler on a level surface strong enough to support it when it is fully loaded.
• To level the unit, adjust the front leveling legs at the bottom of the beverage cooler.
• For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 60°-90°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
• It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the beverage cooler into an exclusive, properly installed-grounded wall outlet.
OPERATING YOUR BEVERAGE COOLER
START-UP PROCEDURES
• Plug the cabinet into the electrical outlet and allow the cooler to run for a minimum of 3 hours.
This will aid in refrigeration performance.
• Do not attempt to adjust the temperature control. The temperature is factory set to provide
maximum performance.
LIGHT CONTROL
• The inside light is controlled by the power. Plug the unit in to turn on the light.
7
17621 South Susana Road, Rancho Dominguez, California 90221
[e-mail]