Use and Care Manual

Operation
Operating conditions
7
Proper operation of the appliance is
guaranteed only if the following conditions are
met:
 The temperature in the room where the
appliance is located conforms to the
climate class stated on the appliance’s
rating label.

Maximum ambient relative humidity:
RH75%.

The appliance must be placed at a
sufficient distance from heat sources ( e.g.,
ovens, central heating, direct sunlight,
etc.).

The appliance must be located in such a
place that it is protected against the effects
of weather.
 Regular maintenance is performed
according to the instructions in this user’s
manual.

The ventilation openings on the appliance
must not be covered.

Correct installation ( e.g. leveling, the
capacity of the system corresponds to
the specifications on the rating label of
the appliance).
Control elements
1) “ ” button
To turn this unit ON and OFF, press and
hold this button for approximately 3
seconds.
2) “
” button
Energy conservation button: Pressing this
button for 3 seconds will turn the energy
conservation mode either ON or OFF. In
this mode, the LED light and display will
be turned off; the °F/°C light will be on.
3) “ ” button (left)
Pressing this button will increase (warm)
the temperature of the upper chamber in
steps of 1°F (or 1°C).
4) “ ” button (left)
Pressing this button will lower (cool) the
temperature of the upper chamber in steps
of 1°F (or 1°C).
5) LED display
Displays temperature for the upper zone.
6) “
“ indicator light
Indicates that compressor is operating.
7) “°C/°F ” indicator light
Will change as the “°C/°F ” button is
pressed.
8) LED display
Displays temperature for the lower zone.
9) “ ” button (right)
Pressing this button will increase (warm) the
temperature of the lower chamber in steps of
1°F (or 1°C).
10) “ ” button (right)
Pressing this button will lower (cool) the
temperature of the lower chamber in steps of
1°F (or 1°C).
11) “°C/°F ” button
Pressing this button switches the indicator
light between °C and °F.
12)
“ ”
button
Turns the interior light ON or OFF. If you
use this button, the light is no longer con-
trolled by the reed switch, and remains ON.
(Light button deactivated when
Energy conservation button is on.)