Instructions / Assembly

Legs (x 2)
OnCloud Hammock Stand
Assembly Instructions
If you have any questions regarding our products,Please visit our website
page: onclouddirect.com or contact us at [e-mail]
Socket Wrench(x1)
7.1” L bolts (x 4)
5 .1” L bolts (x 6)
Medium washers (x 20)
Medium lock nuts (x 10)
Small washers (x 2)
Small lock nuts (x 2)
S Hook (x 2)
Plastic Cap (x 14)
Carabiner clip (x 2)
Eye bolt (x 2)
Medium wrench (x 1)
Small wrench (x 1)
Hammock(x1)
Hardware Included:
Big Parts:
B
C
D
E
F
G
H
I
J
K
L
M
A
N
O
P
Q
Note: Before assembling, please make sure you have all the below parts.
Uprights (x 2)
Center braces (x 2)
G
[1]
Locate the Carabiner Clips(Part J) to the ends
of hammock as shown in figure 14.(The S
hook (Part H) could be used if the hammock is
too tight)
14
Hang the hammock to the Eye bolts as shown
in figure 15.
15
NOTE: DO NOT EXCEED THE LOAD LIMITATION OF 300 LBS.(The load limitation is tested when you
swing back and forth gently on hammock.If you sit still,the load limitation is about 440 LBS)
Caution: Care should always be taken when using your hammock and stand but especially when
using them for the very rst time. Please always use extreme caution when getting into and out of
your hammock. Never exceed the weight capacity of the hammock or the hammock stand. Never
allow young children to use the hammock or stand unaccompanied by an adult. Always inspect your
hammock and stand before each use to assure all parts are appropriately attached and tightened.
Care and Storage:To prolong the life of the wooden stand try to store in a dry location especially
through the winter months. To prolong the life and color of the hammock, please store in a cool dry
place when not in use.
Warning:
[4]