Use and Care Manual

Place the medium washers (Part D) and
medium lock-nuts (Part E) on the end of 8
bolts as shown in Figure 8.
8
Tighten 8 bolts securely using the medium
wrench (Part L) and socket wrench (Part A) as
shown in Figure 9 Repeat this procedure on
the second bolt until tighten all 8 bolts
securely. (Please note this step is very
important to avoid the accidents)
9
Locate 12 plastic caps (Part I) on bolts as
shown in figure 10.(please note the opposite
side of 8.3” bolts needs 4 plastic caps)
10
Locate the eye-bolts (Part K) and place
through the hole on the top of the upright (Part
Q) with the eye facing the inside of the stand.
Place small washer (Part F) then small
lock-nut (Part G) onto the threaded end of the
eye-bolt (Part K) as in Figure 11.
11
Tighten Eye bolt(Part K) with the small wrench
(Part M) as in Figure 12.
12
Locate the Carabiner Clips(Part J) and S
hooks(Part H) and Chains (Part N) to eye bolts
as shown in figure 13.(The S hook could be
used if the hammock is too tight)
13
Hang your hammock to the chain as shown in
figure 14.
14
[3]