Use and Care Manual

Locate the stand legs (Part O) and place on
level surface about 4.3 feet apart as in figure 1.
1
Locate center braces (Part P) and place on
top of the legs (Part O) so that the ends of the
braces curve upward as in figure 2.
2
Locate 5.9’’ bolts (Part C) and medium
washers (Part D). Place medium washer (Part
D) onto bolt (Part C) as in figure 3.
3
Align holes on the top of each center brace
(Part P) with the holes on top of leg (Part O).
Place four 5.9” bolts through the aligned holes
as in figure 4.（Please note: Don’t tighten the
bolts with lock nuts and washers in this step in
order to assemble the wood stand easily）
4
Locate the upright sections (Part Q) and place
between the two center brace pieces (Part P)
as shown in Figure 5.
5
Align the two holes of upright sections (Part Q)
with the two holes in center brace pieces (Part
P). Place medium washer (Part D) onto the
8.3” bolts (Part B) and tap through the center
brace and upright pieces as shown in Figure
6.（Please note: Don’t tighten the bolts with
lock nuts and washers in this step in order to
assemble the wood stand easily）
6
Repeat Step 5 and step 6 to align the another
upright and leg with 8.3” bolts as shown in
Figure 7（Please note: Don’t tighten the bolts
with lock nuts and washers in this step in order
to assemble the wood stand easily）
7
[2]