User`s manual

V1.0 – Feb-09 User’s Manual Page 12 of 18

6 Design-in Support

The EVA1035-H demo board offers the possibility to implement the A1035-H GPS

receiver module temporarily into your design by using the terminal block with 9 con-

nections. To operate the EVA1035-H via this terminal block, please check “Table 3:

Switch settings”.

Please note:

• VCC power input is not protected against reversed polarity

• External supply has to be within the range of 3.3 to 3.6 VDC

• RTC backup: Supercap soldered to the board can be used (*1)

6.1 Terminal Block

The terminal block offers direct access to the A1035-H GPS receiver pins.

1 2 3 4 5 6 7 8 9

Port

nRST

(reset)

RFPWUP

(Status of

analog

section)

ON_OFF

(hibernate

mode /

PTF mode)

RX0 TX0

1PPS

(Pulse Per

Second)

VBAK

(backup

supply)

VCC GND

Table 2: Terminal block description

Figure 8: Terminal block