Specifications
Vincent
27
When switched off the device is internally separated from the AC power. It has no standby circuit, it is
switched on and off at the front panel and not from the remote controller. Four seconds after switching
on the pre-amplifier is operational.
Keep the Level
!
-Button pressed to increase the volume. Use the Level
"
-button to decrease it. You can use
either the front panel buttons or the remote controller buttons. In the process of changing volume the display
changes to indicating the momentary numerical value of the setting. The volume minimum appears at -99dB,
the maximum volume setting is 0dB.
Shortly press the corresponding touch button to change to the desired input channel (Line1-5 or balanced).
You find those buttons at the front panel as well as on the remote controller. For a short period the dis-
play shows only the name of the input channel. As a precaution, prior to changing the input channel the
value of the volume setting should be reduced!
One channel of the system and thus one of the speakers of your system can be adjusted to be more loud
than the other one. This balance adjustment can only be made using the corresponding remote control-
ler buttons. Sometimes this is desirable if you are situated closer to one of the speakers than to the other
one because then you will perceive a volume difference. The channel volume balance can be set in 10
steps to both sides respectively. The maximum difference appears at the setting displaying „+10dB“.
Additionally the display shows the name of the channel that has the higher volume. At „0dB“ both chan-
nels are in balance.
To establish the power supply push the plug of the
power cable into the AC socket on the back panel
and connect the plug on the other side of the
cable to a 220V-240V AC wall outlet.
Notes on Bi-Amping
This mode of operation can only be set up using
W E L C O M E
V O L U M E - 9 9 D B
V O L U M E 0 0 D B
L I N E 1
B A L L + 1 0 D B
B A L R + 1 0 D B
POWER
LINE 1
LINE 2 LINE 3 LINE 4 LINE 5 BALANCED
POWER CABLE CONNECTION
(unsymmetrical) RCA-interconnections and four
main amplifier channels, for example two stereo
main amplifiers connected as seen in (1).
Additionally the speakers must be suited for this.
More information about the cable connections
between main amplifier and loudspeakers is
available in the manuals of those components.
OPERATION
Set the volume
balance
Select the
input channel
Set the Volume
Switch on and off
Display
Display
Display
Display
LEVEL
LEVEL
BAL L BAL R