Service manual
Table Of Contents
- VIZIO L42HDTV10A,GV42L_HDTV Service Manual
- 01-FEATURES
- 02-SPECIFITION
- 03-ON SCREEN DISPLAY
- 04-FACTORY PRESET TIMINGS
- 05-PIN ASSIGNMENT
- 06-MAIN BOARD I/O CONNECTIONS
- 07-THEORY OF CIRCUIT OPERATION
- 08-WAVEFORMS
- 09-TROUBLE SHOOTING
- 10-BLOCK DIAGRAM
- 11-SPARE PATRS LIST
- 12-1COMPLETE PARTS LIST_FOR L42 HDTV10A
- 12-2COMPLETE PARTS LIST_FOR GV42L HDTV
- MAIN BOARD CIRCUIT DIAGRAM_FOR L42 HDTV10A
- MIAN BOARD CIRCUIT DIAGRAM_FOR GV42L HDTV
- MAIN BOARD PCB LAYOUT_FOR L42HDTV10A(LG/AUO)
- MAIN BOARD PCB LAYOUT_FOR GV42L HDTV_LG
- ASSEMBLY EXPLOSION DRAWING_FOR L42HDTV10A_AUO
- ASSEMBLY EXPLOSION DRAWING_FOR L42HDTV10A_LG
- ASSEMBLY EXPLOSION DRAWING_FOR GV42L HDTV_LG
CONFIDENTIAL – DO NOT COPY
Page 7-21
File No. SG-0198
Figure 1
3. READ/RESET COMMAND
The read or reset operation is initiated by writing the read/reset command sequence into the
command register. Microprocessor read cycles retrieve array data. The device remains enabled
for reads until the command register contents are altered. If program-fail or erase-fail happen, the
write of F0H will reset the device to abort the operation. A valid command must then be written to
place the device in the desired state.