Mobile Internet Device S7 User’s Manual This guide may be changed for product improvement without prior notice.
Thanks for purchasing viliv. Please read the precautions throughly before using the product.
Copyright Yukyung Technologies Corp. has the copyright for this guide. Contents of this manual may not be copied or produced in any form or means without prior authorization from Yukyung Technologies Corp. ©2009 Yukyung Technologies Corp. All rights reserved. Certification This device has acquired EMC certification for home use (Class B) and is designed not only for use in residential area but anywhere.
Contents Safety Precautions for Use.................................................. 4 Names of Parts.................................................................... 7 Basic Components...........................................................................7 Front View........................................................................................8 Keyboard..........................................................................................9 Left/Right View...............................
Mob ile I n Device net ter S7 Safety Precautions for Use The precautions below are provided to prevent bodily injury or property damage by using this product correctly. Please observe the precautions. Precautions on Power ■■Do not touch the power adapter with wet hands. ■■Plug the power cord into an outlet with grounded jack. ■■Be sure the plug goes in all the way and is not loose. ■■Do not use your device if it is damaged, including an exposed or peeled power cord.
Mob ile I n Device net ter S7 Safety Precautions for Use Warning Please observe the instructions below. Failure to do may cause heating, fire, explosion, etc. ■■If the battery can be seen to be swollen, there may be imminent danger. Immediately contact the manufacturer or sales representative. ■■Only use an eligible specified charger. ■■Keep the device away from open flames. (Do not put it in a microwave.) ■■Do not leave the device in a car in summer.
Mob ile I n Device net ter S7 Safety Precautions for Use The device functions vary depending on model. Read the relevant precautions for the provided function before using the device. Precautions for GPS ■■When initially operating this device, it is recommended you warm it up for over 15 minutes under a clear open sky and open area.
Mob ile I n Device net ter S7 Names of Parts The appearance of the components below may differ from the actual components and some components are subject to change.
Mob ile I n Device net ter S7 Names of Parts Front View 1 2 2 3 4 5 7 8 6 9 1 WEBCAM Equipped with webcam. 2 Built-in Speakers Equipped with stereo speakers. 3 MENU Button Runs Windows START menu. 4 PIVOT Button Rotates the Windows screen 90 degrees counterclockwise. 5 TFT LCD/Touch Screen Users can operate the device using the touch screen. 6 O peration Indicators Power/Battery Charging Indicator Hard Disk Drive LED Turns on when the system accesses the hard disk drive.
Mob ile I n Device net ter S7 Names of Parts Keyboard The keyboard may be different for each country. 5 1 10 9 6 7 2 8 3 4 1 Function Keys (F1~F12) U sages are different depending on the operating system used and application program. 2 Fn Key This key is used together with function keys. 3 Characters and Numbers There are keys for entering characters, a space key for entering space, number keys from 0 to 9, and other special symbol keys.
Mob ile I n Device net ter S7 Names of Parts Left/Right View 6 1 7 2 8 3 9 4 9 10 5 1 D-SUB It is used to connect an external screen such as monitor or projector. 2 Multi I/O Port I t is used for connecting external video output (component, composite, s-video) and expansion pack. 3 Microphone Port For connecting a microphone. 4 Earphone Port For connecting earphone. 5 Power Adapter Port For connecting power adapter or charging the battery. 6 3G Modem Built-in antenna.
Mob ile I n Device net ter S7 Names of Parts Rear View The figure below shows the rear side of the main body without the battery. (Refer to Page 15 for Separating/Attaching battery.) 2 1 2 3 1 Separating/Attaching Battery P ush the battery downward to separate the battery, as shown in the figure above. 2 Battery Charging Port Connection part of battery terminal.
Mob ile I n Device net ter S7 Installation and Cable Connection Connecting Earphone and Microphone Connect earphone and microphone to the ports located on the left of the device. Notice When connecting external speakers, be sure to connect the standard 3.5-pi stereo cable of the speakers to the earphone jack. Power Connection (Charging Adaptor) The charger is connected to the power adapter terminal on the left side of the station.
Mob ile I n Device net ter S7 Installation and Cable Connection USB Data Link Connection A USB cable is connected to the USB Data Link port on the right side of the station. USB Connection This is used for the connection of external devices, such as digital camera, external HDD, etc.
Mob ile I n Device net ter S7 Installation and Cable Connection Rotating LCD Screen LCD screen can be rotated for the convenience of the user. It can be rotated up to 180 degrees in a clockwise direction. Notice Take care not to use excessive force to rotate the screen more than the allowed 180 degrees, otherwise it may result in a malfunction. Take care not to rotate the screen while the LCD lies flat as it might cause a malfunction.
Mob ile I n Device net ter S7 Separating · Attaching Battery Separating Battery Press the battery separation/lock button on the right of the device in the direction shown in the figure below. Remove the battery. Notice Separate the charger after turning the power of the station off. If not, you may receive an electric shock by a short circuit in the battery power part. Attaching Battery Align the battery in the groove and press it down until a clicking sound is heard.
Mob ile I n Device net ter S7 Basic Operation Turning the Power On/Off Turning the power on Move the power button on the right up while the device is off to turn on the power. ZZ The LCD screen turns on and the main screen is displayed. Turning the power off Use the “Shutdown” menu in the Start Menu to turn off the device while Windows is running.
Mob ile I n Device net ter S7 Basic Operation Using MENU Function MENU To run Start Menu of Windows. Using PIVOT Function Users can change the orientation of the screen to horizontal or vertical for a convenient working environment. PIVOT Press the PIVOT button on the right of the monitor while the device is on. ZZ Pressing the key will rotate the screen by 90 degrees counterclockwise each time. ZZ This function is effective only when Windows is booted up and running.
Mob ile I n Device net ter S7 Basic Operation Set Up for villv Manager viliv Manager is executed by double touching vilivManager on the screen. 1 Wireless LAN Power Turn on/off self-powered wireless LAN function. 2 Camera Power Turn on/off self-powered Camera function. 3 Modem Power Turn on/off self-powered Modem function. 4 Windows Booting Option 1. OFF: Always start with OFF status. 2. Last Status: Start with the last status. 3. ON: Always start with ON status.
Mob ile I n Device net ter S7 Using for the First Time Using for the First Time For each Windows installation process, the installation time may vary depending on the process. Please wait until the installation is complete. 1 Along with the start of Microsoft Windows XP Home, the preparation screen for starting Windows appears as in the following figure. 2 The Windows start screen for setting up computer appears. Click next to continue.
Mob ile I n Device net ter S7 Using for the First Time 4 The screen related to automatic update appears. After the selection, click next. 5 The screen to assign the computer name appears. If you want to assign the computer name later, you can assign in computer control panel → system registration information → computer name. 6 The screen asking “Do you want to register on the internet?” appears. After selecting Yes or No, click next.
Mob ile I n Device net ter S7 Recovery Solution (AMI Rescue) Guide As an image-based OS recovery solution, it recovers to the initial status of shipment from factory when HDD of user cannot be booted from OS or it has problems. Way to Use Recovery Solution (AMI Rescue) 1 Execution of Recovery Solution (AMI Rescue) If viliv logo appears when booting the system (BIOS POST), press the F10 key 1-2 times. ZZ As the logo disappears, Pre-Boot Menu window appears.
Mob ile I n Device net ter S7 Specifications The specifications below may be changed for enhancement of product performance without prior notice. General Specifications Product Name S7 CPU & Chipset Intel® AtomTM 1.33 (Z520)GHz + SCH US15W LCD 7-type WSVGA (1024 x 600) / Touch panel RAM 1GB Storage HDD 60GB / SSD 32GB LAN IEEE 802.11b/g WWLAN (Optional) WiMAX; HSDPA Bluetooth Bluetooth Ver2.
Mob ile I n Device net ter S7 Memo MID 23 English
Mob ile I n Device net ter S7 Memo MID 24 English
Rev. 1.
