Robot VR 301 Owner's Manual • Manuale dell'Utilizzatore • Benutzerhandbuch • Manual del usuario • Manual do Utilizador Manuel de l'Utilisateur • Gebruikershandleiding • Εγχειρίδιο Χρήστη • Kullanıcı Kılavuzu
G Thank you for having chosen the Vileda VR301.
General Warnings G IMPORTANT: Read all instructions before use. Retain instructions for future reference. WARNING: Use the unit only as described in this manual. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. When using any electrical appliance, basic safety precautions should always be observed, including the following, in order to reduce the risk of fire, electrical shock, leaking batteries or personal injury.
G • This appliance may only be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given proper supervision or proper instruction concerning use of the appliance in a safe way and understand the hazards involved. • Children shall not play with the appliance and should only use the appliance as intended. • Cleaning and user maintenance shall not be made by children without supervision.
BATTERY USE AND CARE: G • Leaks from battery cells can occur under extreme conditions. If the liquid gets on the skin, wash it immediately with soap and water. If the liquid gets into the eyes, flush them immediately with clean water for a minimum of 10 minutes and seek medical attention. • This product contains NiMH batteries. Do not incinerate batteries or expose to high temperatures, as they may explode.
G • WARNING: Only use a replacement battery as supplied by the manufacturer. SERVICE: • Before using the machine and after any impact, check for signs of wear or damage. • Do not use the appliance if any part is damaged or defective. • Repairs should be carried out by a service agent or a suitably qualified person in accordance with relevant safety regulations. Repairs by unqualified persons could be dangerous. • Never modify the appliance in any way as this may increase the risk of personal injury.
Product Anatomy G 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Front Bumper Charging Contacts Collision Sensors Handle Clean Mode Buttons Cliff Sensors Side Brush Power Switch Battery Charger Socket Removable Dustbin Filter Vacuum Inlet Main Brushes 1. Power Indicator 2. Charging Station Socket 3. Charging Contacts 4. Docking Sensor 5. Sync Button 1. Link Indicator 2. Speed Indicator 3. Week Display (1=Monday, 7=Sunday) 4. Clock Time Display 5. Scheduling Time Display 6. Power Button 7. Arrow Keys 8.
Battery Charging & Recharging G WARNING: If the battery is damaged in any way, do not attempt to recharge it. Contact Vileda customer service address (see last page). Charge the battery manually for 12 hours before first use. After the first use, charging time is about 4-5 hours Turn the robot’s power switch to OFF when transporting or when in storage, otherwise the battery may become damaged. MANUAL CHARGING: 1.
Battery life is up to 60 minutes and decreases over time. The central button on top of the robot will flash when battery level is low. Then recharging is needed. The Robot will search for and drive back to the Charging Station autonomously in case of low battery during manual cleaning for 60 minutes and/or any scheduled cleaning. Whilst searching for the Charging Station the central button on top of the robot will flash.
Cleaning Modes G The Robot uses its robotic intelligence to navigate autonomously around the room and efficiently clean the whole floor and under furniture. The Robot has 3 cleaning modes: Short ( ■■) Robot cleans for 5 minutes. Ideal for spot cleaning in one area. Medium (■■ ■■) The Robot cleans for 30 minutes. Ideal for mid-sized rooms (up to 25 m²). Large ( ■ ■ ■ ) and Scheduled Cleaning The Robot cleans for 60 minutes and it automatically searches for the Charging Station.
Cleaning and Replacing the Filter G 1. Place the dustbin over a waste bin and slide the two clips to open the fencing plates. 2. Take the filter out of the dustbin by pulling the flaps. 3. Clear the dirt on the filter using the maintenance brush. 4. Insert clean filter or new filter to the dustbin and close the fencing plates. To buy new filters, please contact Vileda customer service address (see last page). Cleaning Main Brushes Main brushes do not need to be cleaned after each use.
Troubleshooting G Problem Possible reason Possible solution Robot does not detect cliffs. • Cliff sensors are dirty. • Clean the sensors with a dry cloth. Main brush does not work properly. • Main brush got stuck and could not rotate. • Clean main brushes. •Main brushes are jammed. •Insert main brushes correctly. •Main brushes are incorrectly assembled. Robot stops cleaning or does not start cleaning and all light indicators are flashing.
For further help, technical advice, or to order spare or replacement parts contact Vileda (address see last page) G Environmental and Product Recycling The Vileda VR301 fulfils the EU directive 2002/96/CE, covering Electrical and electronic appliances and the management of its disposal. The packaging material is entirely recyclable, and marked with the recycling symbol. Follow local regulations for scrapping. Keep the packaging materials (plastic bags, polystyrene parts, etc.
Vileda Product Guarantee G A. SCOPE 1. By this Guarantee, Vileda guarantees the product to be free from defects in materials and workmanship at the date of original purchase for a period of two years from that date. The Vileda company that provides and will honour this Guarantee is designated in this Guarantee or accompanying leaflets or can be found on our website www.vileda.com. 2.
D FHP Export GmbH 69448 Weinheim 05713-20-26-204 pt1/V2