Specifications

- 6 -
LEVELING AND CONNECTING MANIFOLDS
1. Place the broiler in the exact position it is to occupy. If the broiler is to be used in a battery, it is
recommended that it be installed on either end of the battery due to the intense heat and the need
for adequate ventilation. The broiler may NOT be installed next to a deep fat fryer.
2. Using a carpenter's level, level the broiler from front to rear and from side to side. Unless the broiler
is level, it will be difficult to line up the manifold piping, and appliances will not butt tightly.
3. Effective January 4, 1994, Vulcan-Hart Company is in the process of changing gas pipe union
vendors from Flagg to Stockham on all gas heavy duty appliances. During this changeover, there
will be three possible conditions of installation. Please read the information below carefully to
determine the correct installation procedure for your appliance.
a. Broilers with square front tops are now shipped with Stockham gas manifold pipe unions. When
batterying a squared front top appliance with a heavy duty appliance built prior to January 4,
1994, remove the old style Flagg union fitting of the existing field appliance (Fig. 2) from the
manifold pipe and replace it with a Stockham union (Fig. 3).
b. Broilers with rounded front top using the Stockham fitting (Fig. 3) will also require the changeout
described in Item (a). In this event, you will receive two unions. One union will be installed on
the new appliance manifold pipe and one will be packaged unmounted in the oven, broiler or
cabinet base compartments (depending on models). Remove the Flagg union (Fig. 2) from the
existing field appliance and replace it with the prepackaged Stockham union (Fig. 3) before
installing the new appliance.
c. Broilers with rounded front tops shipped with one Flagg union (Fig. 2) will not require the above
changeout.
Questions or concerns regarding the above installation procedures may be addressed by calling
the Vulcan-Hart Service Department [phone].
Fig. 2
Fig. 3
PL-40073
PL-40072