Service manual

PROGRAMMING
4-27
September 1999
Part No. 001-9800-200
Parameter Available Responses Description
CG Value (Rx) Tone number or digital
code
If CG was selected, the tone number from 1-42 is entered. If digital was
selected, the digital code is selected. These numbers are listed in
Table 4-5.
AND Ext (Rx) Yes, No If “Yes” is programmed, an External decoder is “ANDed” with the Call
Guard squelch signal if one is programmed (Section 3.9.7).
CONVENTIONAL GROUP PARAMETERS 2
(Group Parameter Screen 2 is selected by pressing F7 from the Conventional System Screen)
Parameter Available Responses Description
Asn Yes, No Specifies if the group will be selectable. This also changes this parameter
on the first group parameter screen.
Alpha Tag A-Z, 0-9, etc. With the high tier models, specifies the eight-character alpha tag that is
displayed when the group is selected. With low tier models, the group
alpha tag is used only for programming and is not displayed by the trans-
ceiver (Section 3.4.4).
Send T/O (Transmit
Turn-Off Code)
Yes, No If “yes” is programmed, the Call Guard turn-off code is sent when the PTT
switch is released (Section 3.9.5).
T/A (Talk-Around) Yes, No If “yes” is programmed, transmission is on the receive frequency (Section
3.9.4). In addition, if equipped with a T/A option switch, talk-around can-
not be turned off by that switch on the group. “NA” is displayed if talk-
around was disabled on the system screen.
Call LGT (Light) Yes, No Programs if the Call indicator lights when a call is received on that group
(Section 3.5.3).
HRN (Horn) Yes, No Programs if the horn sounds when a call is received on that group (Section
3.5.10).
Table 4-4 Conventional System Parameters (Continued)