Service manual

PROGRAMMING
4-26
April 2001
Part No. 001-9800-203
CONVENTIONAL GROUP PARAMETERS 1
(Group Following Parameter Screen 1 is selected by pressing F6 from the Conventional System Screen)
Parameter Available Responses Description
Asn Yes, No Specifies if the group will be selectable. This also changes this parameter
on the second group parameter screen.
Alpha Tag A-Z, 0-9, etc. With the high tier models, specifies the eight-character alpha tag that is
displayed when the group is selected. With low tier models, the group
alpha tag is used only for programming and is not displayed by the trans-
ceiver (Section 3.4.4).
CHN (Channel) Any channel number from
channel table
Programs the channel selected by the group. These are the channels
assigned in the above channel table, not FCC channel numbers. Press F3 to
display the channel table (Sections 4.7.1 and 4.7.2).
RIC Yes, No Programs if the repeater is equipped with an interconnect controller
(Section 4.7.3).
Tx CG None, TCG, DCG, IDCG Programs the type of transmit Call Guard squelch for the indicated group
(Sections 3.9.5 and 3.9.7).
TCG = Tone (CTCSS), DCG = digital (CDCSS), IDCG = Inverted digital
CG Value (Tx) Tone number or digital
code
If CG was selected, the tone number from 1-42 is entered. If digital was
selected, the digital code is selected. These numbers are listed in
Table 4-5.
AND Ext (Tx) Yes, No If “Yes” is programmed, an External encoder is “ANDed” with the Call
Guard squelch signal if one is programmed (Section 3.9.7).
Rx CG None, TCG, DCG, IDCG Programs the type of Receive Call Guard squelch for the indicated group
(Sections 3.9.5 and 3.9.7).
Table 4-4 Conventional System Parameters (Continued)