Service manual

PROGRAMMING
4-24
April 2001
Part No. 001-9800-203
LTR GROUP PARAMETERS
(The Group Parameter screen is selected by pressing F6.)
Parameter Available Responses Description
Asn (Assigned) Yes, No Specifies if the group will be selectable.
Alpha Tag A-Z, 0-9, etc. With the high tier models, specifies the eight-character alpha tag that is
displayed when the group is selected. With low tier models, the group
alpha tag is used only for programming and is not displayed by the trans-
ceiver (Section 3.4.4).
Group Enc/Dec
(Encode/Decode)
1-250 Specifies the encode (transmit) and decode (receive) ID codes for that
selectable group.
Call Light Enabled, Disabled Programs if the Call indicator lights when a call is received on that group
(Section 3.5.3).
Horn Enabled, Disabled Programs if the horn sounds when a call is received on that group (Section
3.5.10).
Encrypt Enabled, Disabled Programs if encryption is used on calls received and transmitted on that ID
code (Section 3.5.7). The output line controlling encryption must also be
programmed for that function (Section 4.9).
Scan List Yes, No Programs the default scan list status of the group (“Yes” = in scan list).
This programming can be overridden by A/D key if it is enabled (Section
3.7.2).
Transpond Enabled, Disabled Programs if transponding occurs when a call is received on that group
(Section 3.8.9).
Data Yes, No Programs if that group can be used for data transmissions (Section 3.5.5).
Table 4-3 LTR System Parameters (Continued)