Service manual

PROGRAMMING
4-22
April 2001
Part No. 001-9800-203
NOTE: Refer to Section 4.6.5 for more information on programming the parameters in the following table.
Parameter Available Responses Description
Fixed System/ Group
Transmit During Scan
Any system/group
assigned to the bank
If a system/group is entered, it takes precedence over the Scan Revert
Mode programming on the Main Radio Parameters screen if the
transmitter is keyed while scanning is occurring (Section 3.7.5).
Data System/Group Any system/group in the
bank
Programs the default system/group that is selected for a data transmission
if the selected group is not programmed for data (Section 3.5.5).
Emergency System/
Group (high tier only)
Type = always “fixed”
with LTR models
System/Group = System
alpha tag/group number
Programs the emergency system/group that is selected if no emergency
system/group is programmed for the currently selected system. The Tab/
shift Tab keys are used to select/deselect the system from those in the bank
(Section 3.5.6).
Table 4-3 LTR System Parameters
Parameter Available Responses Description
Alpha Tag A-Z, 0-9, etc. Changes the eight-character alpha tag for the selected system. The system
alpha tag is displayed only by high tier models which have the alpha tag
display mode enabled (Section 3.4.4).
Home 1-20 Programs the number of the home repeater of the transceiver (Section
4.7.1).
Area 0, 1 Selects the area of the LTR system. “0” is usually programmed unless two
systems are close enough to interfere with each other. One is then pro-
grammed “0” and the other “1”.
Repeater Interconnect 1-250 Programs the block of Repeater Interconnect ID codes up to all 250. If an
ID code within this block is selected or decoded, the transceiver enters the
interconnect operating mode and telephone calls can be placed or received.
Table 4-2 Create/Edit Bank Parameters Screen (Continued)