Service manual

PROGRAMMING
4-21
September 1999
Part No. 001-9800-200
NOTE: Refer to Section 4.6.6 for more information on programming the parameters in the following table.
Table 4-2 Create/Edit Bank Parameters Screen
Parameter Available Responses Description
Alpha Tag Up to eight alphanumeric
characters
Changes the alpha tag for the selected bank. With low tier models, this is
used only for bank identification during programming because banks are
not selectable or displayed. With high tier models, it is displayed when
selecting banks if multiple bank selection is programmed (Section 3.5.2).
Number of Systems in
Bank
1-16 The number of systems that have been assigned to that bank. Systems are
assigned by pressing F6 (see Section 4.6.6).
Inhibit Transmit
During Block Decode
Yes, No “Yes” disables the transmitter while a call is being received on a block ID
(see Section 3.8.3).
OPTIONAL FIELDS
Scan Select N/A This feature does not apply to LTR versions of this transceiver.
Wide Area Group
Tracking
N/A This feature does not apply to LTR versions of this transceiver.
Home System/ Group Any selectable system/
group assigned to bank
Programs the system/group that is selected by the Home select feature
(Section 3.5.9). With low tier models, a selectable system/group must be
entered.
Priority 1 System/
Group
Type = Disabled,
Selected, Fixed
System/Group = The
number of any selectable
conventional system/
group in the bank
If priority group sampling is used on conventional systems, programs the
Priority 1 system/group. “Selected” = The priority sys/grp is always the
one selected by the transceiver. “Fixed” = The priority system/group is
always the one programmed on this screen. “Disabled” = No priority sys-
tem/group is programmed (Section 3.9.6).
Priority 2 System/
Group
Same as for priority 1
above
If Priority 1 above is “Disabled”, Priority 2 sampling is not available.
Also, either Priority 1 or 2 can be “Selected”, but not both (Section 3.9.6).