Service manual

PROGRAMMING
4-11
September 1999
Part No. 001-9800-200
Figure 4-3 Modify Radio File Screen
is selected by group programming or the T/A option
switch. Channels can be entered into this table and not
assigned to a system or group if desired. The F5 and
F6 keys are pressed to go to the previous or next page,
respectively, and F8 clears all the channels on a page.
With the UHF screen, the F3 or F4 key can be pressed
to automatically enter a transmit frequency 5 MHz
above or below the receive frequency.
Edit Channel Table (UHF Shown)
Test Channel Table (F7)
The test channel table which follows (800 MHz
version shown) is selected by pressing F7 to change
the test channels used in the test mode described in
Section 3.11. The sixteen default test channels shown
in the tables in that section are programmed unless
they are changed in this table. To return to the default
frequency, enter “0” and it is reloaded the next time
the table is displayed.
Edit Test Channel Table (800 MHz Shown)