Service manual

PROGRAMMING
4-7
April 2001
Part No. 001-9800-203
Figure 4-2 Main Menu
4. To display Group Table 2 for that system, press F7
and the screen in Table 4-4 is displayed. Program the
parameters in this screen as described in this table.
5. When finished programming the group parameters,
return to the “Modify Radio File” screen by pressing
F9 or ESC. If creating another conventional system,
repeat this section.
Create/Edit/Delete Bank
One bank must be created with all models even if
bank select is not available or not used. The “Modify
Radio File” screen shown in Figure 4-3 should be on
the screen. Proceed as follows:
1. To create a bank, select “Create Bank” and the
screen in Table 4-2 is displayed. To edit an already
created bank, select “Edit Bank”, and to delete a
bank, select “Delete Bank”. With high-tier models
which can have up to sixteen banks, another bank
can be copied by selecting “Copy Bank”.
2. Program the information in this screen as described
in Section 4.6.6 and Table 4-2.
Linking Systems to the Bank
The programmed LTR and conventional systems
must be linked to a bank to make them selectable.
This also assigns the system number. Press F6
from the Create/Edit Bank screen and link the
systems as described in Section 4.6.6.
Linking Display Numbers to System/Groups
(Low Tier Models Only)
With the low tier models, all programmed system/
group combinations must be linked to a display
number using the Channel Display screen shown
in Figure 4-6. To display this screen, press the F7
key from the Create/Edit Bank screen. Refer to
Section 4.6.6 for more information.
Programming Transceiver
When all the programming described in the
preceding sections is complete, the data is ready to be
downloaded to the transceiver. Press F9 or ESC to
return to the Main Menu in Figure 4-2. Select “Down-
load Configuration File To Radio” and follow the on-
screen prompts. The program performs error checking,