Service manual

PROGRAMMING
4-6
April 2001
Part No. 001-9800-203
systems and groups must first be entered in this
table. FCC channel numbers are not used. With high
tier models, up to three 126-channel tables can be
created for a total of 378 channels.
3. If you want to change any of the default channels
selected in the test mode, press the F7 key to display
and change the test channel table (see Section 3.11).
4. When all applicable information on the screen has
been entered, press F9 or ESC to return to the “Mod-
ify Radio File” screen.
Option Switches
The “Modify Radio File” screen shown in Figure
4-3 should be displayed. Proceed as follows:
1. Select “Define Option Buttons” and the screen in
Figure 4-4 is displayed. This screen displays a like-
ness of the front panel of the transceiver.
2. Program the option switches as described in Section
4.6.3. If a function is assigned to an option switch, it
cannot be assigned as a menu function and vice
versa.
3. When the switches have been programmed as
desired, press F9 or ESC to return to the “Modify
Radio File” screen.
Menu Mode
The “Modify Radio File” screen shown in Figure
4-3 should be displayed. Proceed as follows:
1. Select “Setup Menu Functions” and the screen in
Figure 4-5 is displayed. Program the information in
this screen as described in Section 4.6.4.
2. When all desired information in the screen has been
entered, return to the “Modify Radio File” screen by
pressing F9 or ESC.
NOTE: The channel numbers used to program the fol-
lowing LTR systems and conventional groups are from
the channel table(s) programmed in the preceding
“Main Radio Parameters” section.
Create/Edit/Copy/Delete an LTR System
The “Modify Radio File” screen shown in Figure
4-3 should be displayed. Proceed as follows:
1. To create a new LTR system, select “Create LTR
System” and the screen in Table 4-3 is displayed. To
edit an already created system, select “Edit System”,
to copy another system, select “Copy System”, and
to delete a system, select “Delete System”.
2. Program the information in this screen as described
in Section 4.6.5 and Table 4-3. Press F4 and F5 to
jump between the top and bottom sections of the
screen.
3. To display the group table for the system, press F6
and the screen in Table 4-3 is displayed. Program the
parameters in this screen as described in Table 4-3.
4. When finished programming the group parameters,
return to the “Modify Radio File” screen by pressing
F9 or ESC. If creating another LTR system, repeat
this section.
Create/Edit/Copy/Delete a Conventional System
The “Modify Radio File” screen shown in Figure
4-3 should be displayed. Proceed as follows:
1. To create a new conventional system, select “Create
Conventional System” and the screen in Table 4-4 is
displayed. To edit an already created system, select
“Edit System”, to copy another system, select
“Copy System”, and to delete a system, select
“Delete System”.
2. Program the information in this screen as described
in Section 4.6.5 and Table 4-4.
3. To display Group Table 1 for that system, press F6
and the screen in Table 4-4 is displayed. Program the
parameters in this screen as described in this table
and then press F9 or ESC to return to the system
screen.