Service manual

OPERATION
3-33
April 2001
Part No. 001-9800-203
NO TALK - Indicates that talk-around has been
disabled on the selected conventional system by
programming (see Section 3.9.4).
NOT CONV - Indicates that an attempt was made to
enable a conventional mode feature on an LTR
system.
OUT-LOCK - Indicates that the synthesizer is
unlocked. The transceiver is nonfunctional until lock
is re-established.
OUT-RNGE - Indicates an out-of-range condition.
Once this indication appears, no more access attempts
are made until the PTT switch is released and then
pressed again (see Section 3.10.1).
PRI ON or OFF - Indicates that priority sampling
was just enabled or disabled by the PRI option switch
(see Section 3.9.6).
PRIORTY1 or 2 - Indicates that an LTR or conven-
tional call is being received on one of the priority ID
codes or groups (see Sections 3.8.3 and 3.9.6).
PROG ERR - Indicates an EEPROM read error.
Check transceiver programming or the EEPROM if
this condition persists.
PRG MODE - Indicates that the transceiver is being
programmed.
SQUELCH - Indicates that the conventional squelch
adjust mode is selected (see Section 3.4.6).
SYS SRCH - Indicates that the LTR System Search
mode has been entered (see Section 3.8.8).
TA ON or OFF- Indicates that talk-around was just
enabled or disabled by the TA option switch (see
Section 3.9.4).
TIMEOUT - Indicates that the transmitter has been
disabled by the Time-Out Timer (see Section 3.5.16).
TX DSBL - Indicates that the selected conventional
system is programmed for monitoring only (see
Section 3.9.3).
TX INHIB - Indicates that the transmitter has been
disabled by the Transmit Inhibit feature (see Section
3.8.6).
3.10.4 MENU MODE MESSAGES (HIGH TIER
ONLY)
The following messages are displayed in the
menu mode that is described starting on page 15.
“ON” is displayed to indicate enabled or yes, and
“OFF” is displayed to indicate disabled or no. The
menu mode is not available with low tier models.
BCKLHGT - Backlight
• BRIGHT
• DIM
• OFF
BANK SEL - Bank select
• Alpha tag of programmed banks
ENCRYPT - Encryption on-off
• ON or OFF
HRN ALRT - Horn alert
• ON or OFF
OPTION - Option on-off
• ON or OFF
PRIORITY - Conventional priority group sampling
• ON or OFF
SCN CONT - Scan continue on-off
• ON or OFF
SCN SAVE - Scan list save
•ON = save, OFF = not saved
SCN TYPE - Selects type of scanning
• SYS-GRP - Both system and group
• GRP ONLY - Group scanning only
• OFF - Scanning off, switch disabled
S/G DISPL - Sys/grp display mode (high tier only)
• ON or OFF
STEALTH - Stealth mode select (high tier only)
• ON or OFF