Service manual

OPERATION
3-17
April 2001
Part No. 001-9800-203
3.6.3 USING MENU MODE
To use the menu mode, proceed as follows:
1. Press the FCN option switch twice within 8 seconds
to select the menu mode. The top line indicates the
function being edited, and the bottom line indicates
the current status as follows.
2. To display the various functions that are controllable
by the menu mode (top line indication), rotate the
Select switch. The currently selected status is
displayed for each function.
Menu Mode Display
3. To change the selected status, press the Select
switch. Information displayed for each menu
parameter is shown in Section 3.10.4.
4. To display another menu function, rotate the Select
switch. Then change the status if desired as
described in the preceding step.
5. The selected configurations for the various func-
tions are saved when the menu mode is exited in one
of the following ways:
•Pressing the FCN option switch again
•Pressing the PTT switch
•Automatically when time-out occurs 2 seconds
after a change is made or 8 seconds after no
changes are made.
3.6.4 A/D (SCAN LIST PROGRAMMING)
The A/D option switch is used to add and delete
systems or groups from the scan list. Pressing this
switch changes the status of the displayed system or
group. Refer to Section 3.7.2 for more information.
3.6.5 BACKLIGHT ADJUST
The menu BACKLGHT parameter can be used to
set the backlight for Bright, Dim, or Off as described
in Section 3.4.3. If this feature is not controlled by the
menu mode, the default condition is usually
programmed Bright or Dim so that it is always in that
state when transceiver power is on.
3.6.6 BANK SELECT
With high tier models only, if two or more banks
or systems are programmed, the BANK SEL menu
parameter can be used to select banks. Refer to
Section 3.5.2 for more information.
3.6.7 CALL GUARD SQUELCH DISABLE
The CG option switch disables both receive and
transmit Call Guard squelch on the selected system/
group. Refer to Section 3.9.5 for more information.
3.6.8 EMERGENCY SWITCH
Pressing the EMER switch sets up a high priority
call as described in Section 3.5.6.
3.6.9 ENCRYPTION ON-OFF
The ENCRYPTION menu parameter or an option
switch programmed for encryption allows the user to
override the encryption mode that has been
programmed on the selected group. When the menu
mode is used, the enabled condition is indicated by
“ON” and the disabled mode by “OFF”. When encryp-
tion is enabled, is indicated in the display (high
tier only). Refer to Section 3.5.7 for more information.
3.6.10 FUNCTION SELECT (HIGH TIER
MODELS)
The FCN (function) switch of high tier models
performs the following functions. If this switch is not
programmed or is disabled, these functions are not
available. Refer to Section 3.5.8 for more information.
Menu Mode Select
- FCN/FCN
Home Sys/Grp Select
- FCN/press Select switch
Squelch Level Adjust
- FCN/rotate Select switch
3.6.11 HOME SYSTEM/GROUP SELECT
With high tier models, the home system/group is
selected by pressing FCN and then the Select switch.
Function
Status