Service manual

ALIGNMENT PROCEDURE AND PERFORMANCE TESTS
7-3
April 2001
Part No. 001-9800-203
Enter key. The following information describes the
functions that can be selected.
1. Radio Serial Number - Reads the serial number
stored in permanent memory of the transceiver. This
number cannot be changed and is the same as the iden-
tification number described in Section 1.4.
2. Tune Radio - Displays the Radio Tuner menu
shown in Figure 7-3. Refer to Section 7.2.4 for more
information on the functions in this menu.
3. Change COM Port - Displays a screen that selects
the port that is connected to the RPI. The default is
COM1. If this must be changed (COM2 is used
instead), this function needs to be used only the first
time the program is run. The selected COM port and
color mode (see following F9 description) are stored in
the RADIOTUN.CFG file which is loaded each time
the program is started.
4. Display Tune Parameters - Uploads the current
tune parameters stored in the transceiver and displays
them in a table similar to the one shown below.
5. Quit - Exits program.
F9 - Toggles between the monochrome and color
modes.
ESC - To exit out of the current menu or function,
press the Escape key.
Figure 7-2 Tune Program Opening Screen
7.2.4 TUNE RADIO SCREEN
When transceiver alignment is to be performed,
“Tune Radio” is selected in the Figure 7-2 screen as
described in the preceding section. The screen in
Figure 7-3 is then displayed.
If you want to have the program automatically go
from one adjustment to the next, select “Radio Tune”.
Conversely, if you want to manually select adjust-
ments one at a time, select them individually from
items 2-9.
Figure 7-3 Radio Tuner Menu