Service manual

PULL DOWN MENUS
4-6
October 1999
Part No. 001-2009-201
4.4.1 WRITE SETUP PARAMETERS
This command sends the contents of a file to the
repeater and programs the EEPROM memory in the
Main Processor Card (MPC).
Figure 4-14 WRITE SETUP PARAMETERS
Figure 4-15 PROGRAM WRITE SETUP
4.4.2 READ SETUP PARAMETERS
This command reads the contents of the
EEPROM memory of a repeater and loads it into a
buffer. The contents of the buffer is then displayed to
show the programming of the repeater.
Figure 4-16 READ SETUP PARAMETERS
Figure 4-17 READING SETUP
Program Rptr 1
Ok Cancel
Programming Setup Parameters
Count = 1
Ok Cancel
Read Setup Parms?
Reading Setup Parameters
Attempting access to Repeater
Figure 4-18 HARDWARE PROGRAMMING FLOWCHART
Repeater (1-30)
Home
UID
GoTo
GID
Data Received From Radio
Data Transmitted to Radio
Home
UID
GID
Pri
Stat
Time
HSDB Monitor
RX/TX Data
HARDWARE
RF Data
RF Line MonitorMode Select
Normal
Test
Revisions
Input Monitor
Input Alarm 3/4 Analog Monitor