Service manual

ManualsBrandsViking ManualsComputer equipmentVX 900 MHz LTR

PULL DOWN MENUS

4-4

October 1999

Part No. 001-2009-201

DATA MODEM

This is selected if the Data Modem option is

installed. This option is not compatible with Paging,

TIC, or VNC options.

4.3.2 SELECT REPEATER

Select the repeater number to be programmed or

edited from the pop-up menu (see Figure 4-6). Move

the cursor with the arrow keys to highlight the

repeater number and press Enter.

Figure 4-6 REPEATER LIST

4.3.3 ALARM CONFIGURATION

This programs the input alarm (see Figure 4-8)

and output alarm (see Figure 4-9) configurations and

provides a cross reference screen.

Figure 4-7 ALARM CONFIGURATION

Use the arrow keys to move down the list. Use

the Space bar to toggle through the parameters: Dis-

abled, Active Low, Active High, for each alarm.

INPUT ALARMS

There are four input alarms that can be activated

by external devices (see Section 6.13). These inputs

can be disabled, energized or de-energized. Alarms 3

and 4 can also be analog input.

Repeater List

default

Rptr 1

-------

Rptr 30

Select Which Alarms To Edit

Input Alarms

Output Alarms

Cross Reference

If the input is disabled, the input alarm line is

inactive. When energized and current flow is

detected, the alarm is activated. When de-energized

and no current flow is detected, the alarm is acti-

vated. Analog inputs provide a detection of an analog

input out of limit condition. Select the Low and High

Limit pair to trip an Analog Input Alarm. The High

Limit must be greater in value than the Low Limit

(0.0V-5.0V in 0.1V steps).

Figure 4-8 INPUT ALARMS

OUTPUT TYPE SELECTION

Selects the operation of the Output Alarm. The

available types are:

Active Open - An active alarm opens (no contact)

the output lines.

Active Closed - An active alarm closes (contact)

the output lines.

Figure 4-9 OUTPUT ALARMS

Input Alarm Configuration

Input Type Selection Description

Spacebar

Door 1 open

Door 2 open

Alarm 1 Input Type: Energized

Alarm 2 Input Type: De-Energized

Alarm 3 Input Type: Analog

Alarm 4 Input Type: Analog

Fuel Tank 1/2

Fuel Tank 1/4

High Limit Voltage (Input3): 2.5 Volts

Low Limit Voltage (Input3): 1.6 Volts

High Limit Voltage (Input4): 1.5 Volts

Low Limit Voltage (Input4): 0 Volts

Description

Spacebar

Output Alarm Configuration

Output Type Selection Tx ID

Alarm 1 Output Type: Active Open

Alarm 2 Output Type: Active Open

Alarm 3 Output Type: Active Open

Alarm Tx Rate: 0

Press F2 to Accept

DOOR OPEN

FUEL 1/2

FUEL 1/4

RF HALF POWERAlarm 4 Output Type: Active Closed

120